Confirm that you can ping 10.0.0.6 (assuming that the drive still has that IP address). Confirm that the routing table is clean netstat -rn. Add an alias to bge0 for the 10.0.0.0 network. Take bge1 off the 10.0.0.0 network (look at ifconfig()). (because, if you did, it doesn't seem to be plugged in to the bge1 socket): I'm not sure why it's there, unless you have two, physical Ethernet connections on your machine.Īssuming there is a good reason to have the drive on the 10.0.0.0 network and you don't have a physical network associated with it Having it present with an unattached network is likely causing your routing table to be incorrect. Your /etc/rc.conf would be helpful as well.īge1 doesn't seem to be connected to anything. 
From the switch one port goes to HD and one to the PC.Īgain, without knowing what ifconfig is showing for your configuration, it's hard to tell. Is it causing problem?įor your convenience, I have a switch connected with a wifi modem.
#MAC NETWORK DRIVE NFS MOUNT PC#
In the rc.conf file of my PC beg0 is 192.168.254.21 netmask 255.255.255.0 (which is the netmask given in the hard disk too). NOTE: I mentioned the message regarding reply on beg0 in my first post.
Inet6 fe80::1%lo0 prefixlen 64 scopeid 0x5
0 kommentar(er)
